For those of you who have been following the TV console project, Ive deleted my previous two postings about it and Ill explain why: it turned out that I made a lot of mistakes with it and had to completely re-do the whole thing. Here is a photo of the first effort several days ago:
It looked terrible. The parts didnt fit, the top didnt lay flat on the frame, I screwed up the bottom shelf and tried to improvise a solution. It didnt work.
So the next day I took it apart and completely disassembled it. I cut the legs down by 5 inches and very carefully with assorted wood working clamps and a square, completely re-assembled it. I also replaced the improvised shelf and went and purchased more lumber for the top and re-did that from the original plan I was going to start out with.
Here it is now:
Discussion and Further Plans
I still think the concept of construction brackets for use in household furniture is a good one and Im going to attempt another console next week. Here are some caveats however before I do this again:
Wood-the cedar looks really nice but its just too soft for furniture use. It dents and tears easily and if this were a regular table, it would not hold up to daily wear and tear. So next time Ill use pine or poplar. Also, no more construction grade lumber. Its not seasoned so when you get it home, within a day or two it will begin to twist and crack. Its also too rough. Next time Ill use a higher quality wood.
Brackets: the brackets work well. I primed and painted these and they dont look half bad. It does give the piece a more finished look. But next time Ill use smaller brackets so theyre not so prominent in the design.
Assembly-the devil is always in the details and very much so with the assembly. The brackets have to fit the lumber very snugly in order for this entire system to work properly and all the part to fit together correctly. Its imperative that you proceed slowly and carefully and clamp the brackets to the 2x4s before you screw them together. Also check the squareness with a carpenters square as you proceed. This will give you a much nicer appearing piece at the end and the parts will fit together better.
Design-You cant make a silk purse out of a sows ear-remember, this is fundamentally a dressed up construction piece. You can make it look nicer by taking your time and carefully considering just how this will fit inside your home and what it will look like along with all your other furniture. Its never going to be fine furniture no matter what you do. My furniture is a little more rustic in appearance so this will fit in but its going to reside in my bedroom with a tv, a dvd player, lots of other stuff, and a cat or two on it and for this its adequate.
I am going to make another console as I really need some furniture at the moment and Ill carefully post about that. That will probably happen next week so stay tuned.
Now, I need to turn my attention to the fall art show so thats what well look at next.
More later,
VW
No comments:
Post a Comment